ֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹֹ
The Speed Range Selector (16) is located on the left side of the
Headlight Housing. It has two positions:
Mark “1” (lower position): Low speed - up to 6 km/h
(3.1 mph).
Mark “2” (upper position): High speed - 10 km/h
(6.2 mph).
Do not shift the selector while the SE is in motion.
Note: When driving the SE inside a building or in a crowded
area, use only position 1 (Low speed).
Operating Lever (red)
and Manual Hand
Brake
To start driving, squeeze the Operating Lever (18) gently until you
reach the desired speed.
The speed is directly proportional to the deflection of this
Lever .
To stop - release the Operating Lever (18). The SE will stop
gradually.
Additionally, emergency braking is possible using the Manual
Hand Brake (17).
Note: Hand Brake is usually assembled on the Left Handle Bar
but sometime it is assembled on the Right side.
Before turning, shift the “Turn Signal Switch” (19), on the Handlebar
to the desired direction - left for left, right for right. This will activate
blinking lights on the rear fenders. A warning buzzer also sounds (in
certain models only and subject to local ordinances).