1. Insert the Charging Plug (2) into the Charging Socket (3) located on the
Panel at the front of the Batteries Cover, at the center.
Make sure the plug is fully inserted into the socket.
2. Plug the power cord of the charger into a wall outlet.
3. When charging is completed and you are ready to go - unplug the charger
from the wall outlet and remove the charger plug from the SE.
4. In ideal storage conditions, batteries which were charged to full capacity and
were not used should be recharged every 6 months.
5. If you are planning not to use your SE for an extended period of time, we
recommend charging it for two days and then disconnecting the batteries.
6. If you have not used your SE for an extended period of time, charge the
batteries for at least 24 hours before driving.
Note: There is NO need to disconnect the Charging Plug promptly
after the charging is complete.
However, DO NOT leave the Charger connected to the batteries FOR
MORE THAN TWO WEEKS.
As long as the Charging Plug is in the Charger Socket, the electronic
control of the SE automatically cuts all power to the motor and the
SE cannot be driven.
To Next Page
Loading...
