Ensure the battery is installed in a dry and well-ventilated location.
The installation position must be away from direct sunlight and rain.
The installation position must be far away from potential sources of fire..
The installation position must be far away from all sources of water.
Do not install the equipment in locations that contain flammable g
ases and/or
flammable liquids.
The operation and service life of the battery depends on the operating temperature.
Operate the battery at a temperature equal to or better than the ambient temperature.
The recommended operating temperature range is from 0°C to 30°C.
Please use appropriately insulated tools for installation and maintenance.
Please check the LED status indicator when the battery is powered on.
Please ensure the communication cable is connected correctly between the
battery and the inverter.
Please check for inverter alarms and the SOC reading once communication is
established between the inverter and the battery.
The
products have passed UN38.3 certification.
The products have MSDS documents available.
• The products belong to class 9 dangerous goods.
• Being dampened by rains, snows, or falling into water.
• Falling down or mechanical impact.
• Being upside-down or tilted.
2 . 4 Transportation Safety
Environment SafetyElectrical Safety
Before installation, ensure that the equipment is intact. Otherwise, electric
shock or fire may occur.
Do not connect or disconnect power cables when battery is power-on. Which
may cause electric arcs and sparks moreover fire or personal injury.
Before connecting a power cable, check the positive or negative connectors
are correct.
05 06
Do not connect the battery with different batteries in parallel.
Do not connect the battery with AC supply directly.
Do not connect the battery with PV
wiring
directly.
Do not connect the batteries in series.
Do not connect the battery to faulty or unqualified inverter or charger.
Do not create short circuits with the external connection.
Make sure the grid is cut off and the battery is powered off before
maintenance.
Make sure the earth cable is connected correctly before operation.
Recharge the battery in every six months if not in use.
Recharge the battery within 10 days after the battery is fully discharged(SOC=0%).
Ensure the battery cable is installed correctly.
When the battery is being installed or repaired, ensure the battery is
powered off and and isolated. Using a multimeter check to ensure there is no
voltage in the positive and negative termi
nals.
Please
protect the packing case from the following situations: