EN5
www.afx-light.com
consisting of a (male) 3 pin connecter. Then, proceed to connect from the output as stated above
to the input of the following xture and so on.
Often, the set up for Master-Slave and Stand-alone operation requires that the rst xture in the
chain be initialized for this purpose via either settings in the control panel or DIP-switches. Se-
condarily, the xtures that follow may also require a slave setting. Please consult the '' Operating
Instructions» section in this manual for complete instructions for this type of setup and congu-
ration.
CONTROL PANEL
UP
DOWN
MENU ENTER
8.8.8.8.
To access the main menu press the MENU button. Press the UP or DOWN
buttons until you reach function you wish to change. When you reach the
function you wish to change, press the ENTER button. When a function
is selected, use the UP or DOWN buttons to change the function settings.
Once your changes are made, press the ENTER button.
FUNCTION MENU
DMX Address A001---A512
Channel Mode 13 ch, 44ch
Show Mode Sound, Auto
Slave Mode Master, Slave
Black Out YES, NO
Sound State ON, OFF
Sound Sense 0 –100 off – the most sensitive
Pan Inverse YES, NO
Tilt1Inverse YES, NO
Tilt2Inverse YES, NO
Tilt3Inverse YES, NO
Back Light On, Off
Auto Test Automatic test
Fixture Time 0----9999
Firmware Version V104
Defaults YES,NO
System Reset YES,NO
FUNCTION MODE
DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
1. Press the either the MENU, UP or DOWN buttons until “ADDR” is displayed, press ENTER.
2. The current address will now be displayed and ashing. Press the UP or DOWN buttons to nd
your desired address. Press ENTER to set your desired DMX address.
Channel Mode: The unit has 13 or 44 channels that can receive the International DMX signal.
Show Mode: The user can select between [Sound] and [Auto] mode
Slave Mode: In [Slave] mode, you can chose [Master] mode and [Slave] mode.
Black Out: Select [YES] or [NO] to black out or not
Sound State: Sound control [ON] or [OFF]
To Next Page
Loading...
Need help?
General
