PF3000 Cotton Yield Monitor
Ag Leader Technology
Setup Overview
March 2002
Important Notices
The PF3000 must be set up before field operation, but before you begin the
setup procedures, read the following notices:
• The PF3000 is a software upgradeable monitor. Ag Leader Technology
will periodically offer free operating program upgrades to increase the
capabilities of the PF3000. To receive the program upgrade, you
must send in the registration form found at the beginning of the
Operator’s Manual.
• If you plan to make yield maps on your own computer, you will need to
use a mapping program that can process data from the PF3000. Memory
cards can be ordered through your Ag Leader Technology dealer.
Section Contents
This setup section contains instructions for the following items. The
operating modes that the instructions pertain to are also listed.
Item Page
Console Setup 2-3
Vehicle Setup 2-5
Cal Set Setup (see calibration section)
Card Setup 2-10
Swath Setup 2-15
Marker Setup 2-17
Creating, Naming Fields & Loads (1
& 2
Pick) 2-19
Memory Setup 2-24
Sensor Setup 2-26
Using Power
Supply
The PF3000 console does not need to be in the vehicle to set it up. You can
use the provided power supply (plugs into 120v outlet) to power up the
console inside your home or shop.
To Next Page
Loading...
Need help?
General
