PF3000 Cotton Yield Monitor
Ag Leader Technology
Logging Map Data on Card
March 2002
Formatting Card
The memory card must be formatted with a DOS format. You can format
the card using the PF3000 or your computer and card reader (using
Windows 3.1 or Windows 95 and 98. Windows NT is not supported). Refer
to the instructions for formatting a card in the Card Setup section.
IMPORTANT: Formatting a card erases all data on the card.
Copying Data to
Log File
IMPORTANT: If you have logged to two or more files during
the day without coping to card; when you power down the
monitor, only the LAST log file will be copied to card.
To copy memory to log files that are not set as the current log file, press the
SETUP key and CARD key. Press the SHOW FILES key and select one of
the log files. Press the FILE OPTIONS key and press the COPY TO FILE
key.
At the card setup screen, press the COPY TO CARD key to copy memory to
the file set as the log file (this is the same copy to card function that happens
during shut down).
Logging Data to a
When the monitor logs data to a memory card, a small arrow that points to
the memory card symbol at the top right corner of the display appears.
Operating Mode Condition to start logging to card
Cotton Harvest Mode Picker units engaged (fan speed must be above
2500 rpm) and the monitor is counting area.
Checking Free
To check the percent of space free on the card display CARD INFO.
* * *
To Next Page
Loading...
Need help?
General
