AGA PRO+ APRO36DF - Checking the Parts; Additional Materials You May Need

INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
25
Checking the parts:This will allow the range to be moved for cleaning or
servicing. Also, make sure your oor covering will withstand
180°F (80°C); see the ‘Installation Safety Instructions’ section.
Make sure the wall coverings around your range can
withstand the heat generated, up to 200°F (90°C), by the
range; see the ‘Installation Safety Instructions’ section.
You will also need the following tools:
1. Electric drill
2. Masonry drill bit & anchors (only required if installing
the range on a stone or concrete oor)
3. Steel tape measure
4. Phillips head screwdriver
5. Flat head screwdriver
6. 2.5 mm Allen key (supplied with the range)
7. Spirit level
8. Open-end or adjustable wrench
9. Pencil and ruler
10. Pipe wrenches
Additional materials you may need:
• Gas line shut-off valve.
• Pipe joint sealant or UL-approved pipe thread tape with
Teflon* that resists action of natural and LP gases.
• Flexible metal appliance connector (½’’ I.D.). A 5foot
length is recommended for ease of installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
• Flare union adapter for connection to gas supply line
(¾’’ or ½’’ NPT x ½’’ I.D.).
• Flare union adapter for connection to pressure regulator
on range (½’’ NPT x ½’’ I.D.).
• To protect any floor covering under the range a sheet of
¼’’ thick plywood or equivalent large enough to stand
the range on.
3 grates Leveling tool and Allen key
ArtNo.215-0011 - Elan 90
pan support
ArtNo.020-0004 - Tools USA
2 full width racks 1 telescopic rack with runners
ArtNo.326-0012 - Oven shelf USA
2 broiler pans with grids 3 energy saving racks
ArtNo.331-0008 - 90SC
grill pan & trivet
ArtNo.326-0015 - Energy saving shelf (Falcon)
2 sets of side supports Toe kick
ArtNo.350-0007 - Plinth USA
Side panel extension
Reducer plates for conduit
connection
ArtNo.351-0001 - Side extension
panel USA
ArtNo.020-0012 Reducer Plates USA
Conversion kit from natural
gas to propane gas
Anti-tip device
ArtNo.020-0019
Conversion Kit USA
ArtNo.070-0003 -
Anti-tip bracket V2
Control knob (°C)