What to do if there is a calculation error on Agatec DM100 Analytical Instruments?
If you encounter a calculation error while using the Agatec Analytical Instruments, the suggested solution is to perform the measurement again. The cause of the problem is a calculation error.
What to do if the laser beam is interrupted on Agatec DM100 Analytical Instruments?
If the laser beam is interrupted while using the Agatec Analytical Instruments, the suggested solution is to repeat the measurement. The cause of the problem is interruption of the laser beam.
What to do if the temperature is too high on Agatec Analytical Instruments?
If the temperature is too high when using the Agatec Analytical Instruments, let the device cool down. The cause of the problem is high temperature.
What to do if the temperature is too low on Agatec DM100 Analytical Instruments?
If the temperature is too low when using the Agatec Analytical Instruments, warm the device up. The cause of the problem is low temperature.
What to do if I get a measuring error due to too much background light on Agatec DM100?
If you are getting a measuring error because there is too much background light when using the Agatec Analytical Instruments, shadow the target area. The cause of the problem is too much background light.
What to do if the reception signal is too weak or the measuring time is too long on Agatec DM100?
If the reception signal is too weak, or the measuring time is too long when using the Agatec Analytical Instruments, change the target surface (e.g. white paper). This is because the reception signal is too weak, or the measuring time is too long.
What to do if the input signal is too high on Agatec DM100 Analytical Instruments?
If the input signal is too high when using the Agatec Analytical Instruments, change the target surface (e.g. white paper). The cause of the problem is high input signal.
What to do if the measurement is outside of the measuring range on Agatec Analytical Instruments?
If the measurement is outside of the measuring range when using the Agatec Analytical Instruments, mind the range. The cause of the problem is that the measurement is outside of the measuring range.
General| Accuracy | ±1.5 mm |
|---|---|
| Laser type | 635 nm, <1 mW |
| Operating temperature | -10°C to +45°C |
| Protection class | IP54 |
| Weight | 100 g (including battery) |
| Type | Laser Distance Meter |
| Measuring range | 0.05 m to 100 m |
| Laser class | Class II |
| Battery type | 2 x AAA |
| Measurement Range | 0.05 m to 100 m |
| Resolution | 1 mm |
| Light Source | Laser diode |
| Detector | Photodiode |
| Power Supply | 2 x AAA batteries |
| Battery life | Up to 5, 000 measurements |
To Next Page