6/70
7 Initial operation
Insert the batteries
See drawing E:
 To ensure a reliable use, use exclusively alkaline batteries.
 Remove battery compartment cover.
 Insert alkaline batteries (2 x AAA) pay attention to the correct polarity.
 Close the battery compartment cover.
Changing the batteries
 Change the batteries when the battery symbol is flashing permanently.
8 How to use
8.1 Measuring conditions
The quality of the measurement depends on the surfaces to which you are measuring.
Measurement errors
Measuring errors are possible in case of:
Î colourless fluids (e.g. water)
Î clean, translucent glass
Î styrofoam or similar semi-translucent surfaces
Î strongly reflecting targets that deflect the laserbeam
Î measurements aimed at moving objects
Causes:
Î Strongly reflecting targets deflect the laser beam and cause measuring errors.
Î Non-reflecting, dark surfaces increase the measuring time.
For constantly high-quality measurements
 Perform control measurements periodically.
 Perform control measurements before and after important measurements.
Damage to property due to use of wrong measuring results!
 Avoid measuring errors due to unexpected events during distance measuring.
 Perform a control measurement.
Agatec DM100.book Page 6 Thursday, April 1, 2010 12:48 PM
To Next Page
Loading...