42
4450A EN 20060221Advanced operation (‘Key-operator mode’)
CR 85-X DIGITIZER
Cleaning the exterior
1 Switch off the Digitizer by following the procedure as described in ‘Switching off the
CR 85-X’ on page 24.
2 Remove the power plug from the socket.
3 Wipe the exterior of the Digitizer with a clean, soft, damp cloth.
Use a mild soap or detergent if required but never use an ammonia–based cleaner.Be
careful not to get any liquid in the power cord port.
4 Plug in the Digitizer and switch it on by following the procedure as described in
‘Switching on the CR 85-X’ on page 22.
Note: Do not open the machine for cleaning. No components inside the
machine require maintenance or cleaning by the user.
Caution: Take extreme care that no water infiltrates the machine!
To Next Page
Loading...
