DX- D 400
User Manual
iv
0232F EN 20191213
Section Page
6 DX-D OVERLAY CONSOLE AND
DX-D OVERLAY CONSOLE WITH APR 123....................................
6.1 Radiography and General Controls 124....................................
6.1.1 Power ON / OFF 124.............................................
6.1.2 Workstations Selection 124.......................................
6.1.3 Focal Spot Indicators and Selectors 125............................
6.1.4 Radiographic Parameters 126.....................................
6.2 Automatic Exposure Control (AEC) 128....................................
6.2.1 Rapid Termination 129............................................
6.3 Anatomical Programmer (APR) (Optional) 129..............................
6.4 Exposure Controls and Indicators 132.....................................
6.5 X-Ray Handswitch 133..................................................
6.6 Heat Units 133.........................................................
6.7 Exposure Counters 133.................................................
6.8 Self-Diagnosis Indicators 134............................................
6.9 Error Codes 135........................................................
7 OPERATING SEQUENCES 139...............................................
7.1 Start-UP Routine 139...................................................
7.2 X-Ray T ube Warm-Up Procedure 139.....................................
7.3 Radiographic Operation 140.............................................
7.4 AEC Operation 141....................................................
7.4.1 How to Verify the Proper Functioning of the AEC 141.................
7.5 APR Operation 143....................................................
7.6 Fail-Safe Function 143..................................................
8 PERIODIC MANTEINANCE 145...............................................
8.1 Operator Tasks 145.....................................................
8.2 Service Tasks 146......................................................
To Next Page
Loading...
