DX- D 600
User Manual
0242F EN 20181218
64
4.1.2 MOVEMENTS CONTROLS AND INDICATORS
AUTO- CENTER. Get active the Auto-center function to align the X-ray T ube
with the DR Detector. RAD Table or RAD W all Stand Workstations must be
selected. It is not active for Direct Workstation.
AUTO- TRACKING. Get the Auto-tracking motion active. It is possible to
activate it just when the X-ray Tube is aligned with DR Detector of the selected
Workstation, RAD Table or RAD Wall Stand Workstations. It is not active for
Direct W orkstation. Auto-tracking function remains active for 5 minutes after
Ceiling Suspension becomes inactive.
PARKING POSITION. It indicates when the X-ray Tube has reached to the
configured Position or Auto-position. Active for all Workstations.
DETENT SKIPPER. Press to activate the Detent Points Skipper. No Detent
Point is activated when active. Active for all Workstations.
4.1.3 CEILING SUSPENSION STATUS INDICATOR
Current status of Ceiling Suspension are indicated at the right bottom corner
of the Touchscreen Console. The available status are:
The Ceiling Suspension is ready to make X-ray exposures. It is aligned with
the DR Detector. The Ceiling Suspension and the DR Detector are aligned
when the central beam of the X-ray Tube hits inside the previously defined
image reception area. This area is defined by Service Engineer during
configuration and calibration procedure.
The Ceiling Suspension is in motion. Not possible to make X-ray exposures.
The Ceiling Suspension is stopped and not centered with the
DR Detector. Not possible to make X-ray exposures.
The Ceiling Suspension is not synchronized with the Generator.
X- ray Interlocks. Unable to make exposures. Press on it to know the reason
of the Status (refer to Section 4.2.3.5 “ X-ray Interlock” for further details).
To Next Page
Loading...
