30
lower voltage.
6.2 Flash will not fire
1. The flash is set to OFF: Set the flash to Auto or on.
2. Flash has not been fully charged the flash takes a few seconds to charge
up while the operation LED is blinking. Flash light is fully charged when the
operation LED turns off.
3. Battery level is low: When the battery indicator does not show a fully
charged battery, the voltage is low for the flash to work. Please change new
batteries.
6.3 Image is blurred / out of focus
1. Subject is out of focal range. Ensure that there is at least 1.5 m (5ft )
between the camera lens and subject.
2. Camera moved: Hold the camera steady while taking the picture. When
flash is on, hold the camera steady until flashes have fired two times. (First
flash is to reduce a red-eye phenomenon and to detect the brightness of
the target).
To Next Page
Loading...
