18-50
Measure Commands
VTOP
The query returns the measured voltage at the top of the specified source.
Returned Format [:MEASure:VTOP] <value>[,<result_state>]<NL>
<value> is the voltage at the top of the waveform. If SENDvalid is ON, the <result_state> is
returned with the measurement result. Refer to Table 18-4 on page 18-39 for a list of the
result states.
Example 10 OUTPUT 707;”:SYSTEM:HEADER OFF”
20 OUTPUT 707;”:MEASURE:VTOP?”
To Next Page
Loading...
