6-6
Error Messages
Error Messages in Alphabetical Order
CANNOT FORMAT DOS DISKS ON THIS DRIVE
Error Number
185
You have attempted to initialize a floppy disk to DOS format on an external disk
drive that does not support writing to all 80 tracks of the double density and
high density disks. The older single-sided disks had only 66 tracks and some
disk drives were limited to accessing that number of tracks. To format the disk,
either choose another external disk drive or use the analyzer's internal disk
drive.
CANNOT MODIFY FACTORY PRESET
Error Number
199
You have attempted to rename, delete, or otherwise alter the factory preset
state. The factory preset state is permanently stored in ROM and cannot be
altered. If your intent was to create a user preset state, you must create a new
instrument state, save it, and then rename it to “UPRESET”. Refer to Chapter
8 , “Preset State and Memory Allocation” for more detailed instructions.
CANNOT READ/WRITE HFS FILE SYSTEM
Error Number
203
The disk is being accessed by the analyzer and is found to contain an HFS
(hierarchical file system) or files nested within subdirectories. The analyzer does
not support HFS. Replace the disk medium with a LIF or DOS formatted disk
that does not contain files nested within subdirectories.
CAN'T STORE/LOAD SEQUENCE, INSUFFICIENT MEMORY
Error Number
127
Your sequence transfer to or from a disk could not be completed due to
insufficient memory.
CAUTION: CORRECTION OFF: AUX CHANNEL(S) DISABLED
Error Number
215
This message is displayed when correction is forced off due to a stimulus change
that is not compatible with the current calibration while an auxiliary channel is
enabled. The auxiliary channels are restored when correction is turned on by
pressing .
CAUTION: FLOPPY DISK IS FULL
Error Number
218
This message is displayed if you try to save files to the floppy disk that does not
have enough memory to perform the save task. Correct by inserting a new floppy
disk in the front panel disk drive or by erasing files from the current floppy disk.
CAUTION: TOO MANY SEGMENTS OR POINTS
Information
Message
This message is displayed if you try to insert too many segments or points using
your current function.
Cal
To Next Page
Loading...
Need help?
General
