Hardkey and Softkey Reference ESG Family Signal Generators
Utility
4-114 User’s Guide
Clear Text
Press this softkey to delete the existing file name in the active entry
area. When you copy from one file to another, the same file name is
given to the new file unless you change it. Press
Clear Text to delete the
existing file name and then enter in a new file name using the editing
keys provided.
Softkey Location:
Utility > Memory Catalog > Copy File > Editing Keys >
Clear Text
Copy File
Press this softkey to copy and rename a file in the displayed catalog of
files. To copy a file, first select the file from the displayed list by
scrolling through the list using the front panel knob or the up and down
arrow keys. When the desired file is highlighted, press
Copy File. The
message
Copy to: "<file_name>" is displayed in the active entry area
where "<file_name>" is the name of the currently selected file. Your
copied file will have the same name as the original file, so you must
rename it. To rename the copied file, the following editing capabilities
are provided:
•The
Editing Mode Insert Replace softkey in the Editing Keys menu
toggles the editing mode from inserting text to replacing text.
Insertion mode causes text to be entered in the position directly to
the right of the cursor. Replacement mode causes the text to be
entered in the position held by the cursor (replacing any existing
text in that position).
•The
Clear Text softkey in the Editing Keys menu deletes all of the
existing text in the active entry area.
• Use the left and right arrow keys to position the cursor. Use the front
panel knob, or the direct editing softkeys, to enter an alphabetic
character, numeral, or special character.
When you have entered the new file name, press the
Enter terminator
softkey. If you have changed your mind, press the
Return hardkey. Once
you press
Enter, the new file is stored and displayed immediately in the
catalog list.
Softkey Location:
Utility > Memory Catalog > Copy File
To Next Page
Loading...
Need help?
General
