Hardkey and Softkey Reference ESG Family Signal Generators
Utility
4-136 User’s Guide
Screen Saver Mode
This softkey toggles between Light Only and Light & Text mode for the
screen saver. When you set the screen saver to
Light Only, only the
display light is turned on and off. When you set the screen saver to
Light & Text, the display light and the text are turned on and off.
Screen saver mode is a persistent state; it is not affected by an
instrument preset or by a power cycle.
Softkey Location:
Utility > Display > Screen Saver Mode
Screen Saver Off On
This softkey toggles the signal generator’s screen saver on and off. With
the screen saver on, the display is turned off after a period of time with
no input from the front panel. The display turns back on when any front
panel key is pressed. The screen saver is set to
Off at the factory. You
can turn it on by pressing
Utility > Display Screen Saver. Each time you
press
Screen Saver Off On the selection toggles between Off and On.
You can adjust the screen saver mode to turn the light on and off or to
turn both the light and text on and off. Refer to the
Screen Saver Mode
softkey description in this section.
The screen saver delay is set to 1 hour at the factory. You can change
the delay time. Refer to the
Screen Saver Mode softkey description in this
section.
Screen saver is a persistent state; it is not affected by an instrument
preset or by a power cycle.
Softkey Location:
Utility > Display > Screen Saver Off On
Select Item
Press this softkey to select the highlighted option from the list of
hardware options. Selected options show an X in the column to the left
of the option number. Two operations can be performed upon the
selected options. The signal generator can be configured with these
options enabled (by pressing the
Proceed With Reconfiguration softkey), or
the selected options can be calibrated (by pressing the
Calibrate Selected
Items softkey). For more information, refer to the descriptions of the
softkeys mentioned, or refer to Chapter 2, “Using Functions,” for an
example of enabling options.
Softkey Location:
Utility > Instrument Adjustments > Hardware Options >
Select Item
To Next Page
Loading...
Need help?
General
