Programming the Status Register System
Status Groups
Chapter 3124
Baseband Operation Event Enable Register
The Baseband Operation Event Enable Register lets you choose which bits in the Baseband
Operation Event Register can set the summary bit (bit 7 of the Status Byte Register).
Command: STATus:OPERation:BASeband:ENABle <value>, where
<value> is the sum of the decimal values of the bits you want to enable.
Example: To enable bit 0 and bit 1 so that whenever either of those bits is set to 1, the
Baseband Operation Status summary bit of the Status Byte Register is set to 1.
Send the command STAT:OPER:ENAB 520 (512 + 8).
Query: STATus:OPERation:BASeband:ENABle?
Response: Decimal value of the sum of the bits previously enabled with the
STATus:OPERation:BASeband:ENABle <value> command.
To Next Page
Loading...
