Chapter 4
Front-Panel Key and SCPI Command Reference
Measurement keys
174
Front-Panel Key and SCPI Command
Reference
4.4.1.2.3 Avg Number
Sets the number that will be averaged. After the specified number (average counts) have been averaged, the
averaging mode (termination control) setting determines the averaging action.
4.4.1.2.4 Avg Mode
Selects the type of termination control used for averaging. This determines the averaging action after the
specified number of average count is reached.
• Repeat - After reaching the average count, the averaging is reset and a new average is started
• Exponential - Each successive result after the average count is reached, is exponentially weighted and
combined with the existing average.
Example: :FCO:GLEN 200.0 ms
:FCO:GLEN?
:FCO:GAUT OFF
:FCO:GAUT?
Mode: MRECEIVE
Key Path:
Meas Setup
Remote Command: [:SENSe]:FCOunter:AVERage:COUNt <integer>
[:SENSe]:FCOunter:AVERage:COUNt?
[:SENSe]:FCOunter:AVERage[:STATe] OFF|ON|0|1
[:SENSe]:FCOunter:AVERage[:STATe]?
Preset: 25, ON
State Saved: Saved in instrument state.
Min: 1
Max: 8192
Example: :FCO:AVER:COUN 10
:FCO:AVER:COUN?
:FCO:AVER:STAT OFF
:FCO:AVER:STAT?
Mode: MRECEIVE
Key Path:
Meas Setup
Remote Command: [:SENSe]:FCOunter:AVERage:TYPE REP|EXP
[:SENSe]:FCOunter:AVERage:TYPE?
To Next Page
Loading...
Need help?
General
