310 Chapter 6
Menu Maps
N5531S Measuring Receiver System Measurement Key Flow
Directions for Use
Refer to the following notes to utilize the key-flow diagrams:
• Start from the upper left corner of each measurement diagram. Go to the right, and go from the top to
the bottom.
• When changing a key from auto (with underline) to manual, just press that key one time.
• When entering a numeric value for frequency, a value with units, use the numeric keypad and
terminate the entry with the appropriate unit selection from the softkeys displayed.
• When entering a numeric value for a unitless value, like Avg Number, use the numeric keypad and
terminate the entry with the
Enter front-panel key.
• Instead of using the numeric keypad to enter a value, it may be easier to use the front-panel knob or
Up/Down arrow keys.
Table 6-1 Menu Map Legend
Icon Description
This represents the analyzer front-panel key.
An oval represents additional levels of menus.
This box shows how the softkey default condition is displayed. Default parameters or
values are underlined wherever possible.
A dagger to the left of a softkey indicates that when the key is pressed this is an active
function.
A double-dagger to the left of the softkey indicates a function that is not always
available. It is dependent on other instrument settings.
A bar on the left of two or more softkeys indicates that the keys are a mutually
exclusive choice.
To Next Page
Loading...
Need help?
General
