4 Installation Guide
General Information E444xAU Option H37
Installation Procedure
Installation Procedure
Removing the Feet, Handles and Covers
NOTE
Keep all of the hardware (screws, nuts, etc.) for re-use when installing the
assemblies.
Follow the steps outlined below to install the Option H37 retrofit kit.
1. Remove the four rear panel feet on the PSA using a #20 Torx driver. Refer to
Figure 1. Torque rear panel feet to 21 in-lb when re-installing.
Figure 1 Rear Panel Feet
2. Remove the two side handles on the PSA by using a #20 Torx driver. Refer to
Figure 2. Torque side handles to 21 in-lb when re-installing.
Figure 2 Side Handles
To Next Page
Loading...
