Service Guide E8364-90038 3-3
PNA Series Microwave Network Analyzers Tests and Adjustments
E8362C, E8363C, E836C Information in This Chapter
Option H11, IF Access,
Operation Verification
How to verify the operation of Option H11, IF access.
Page 3-29
Performance Tests (Agilent
N7840A Software
Package)
a
A brief summary of each performance test in the Agilent N7840A
software package:
• Source Power Accuracy Test
• Source Power Linearity Test
• Frequency Accuracy Test
• Trace Noise Test
• Receiver Compression Test
• Noise Floor Test
• Calibration Coefficient Test
• System Crosstalk Test
• Dynamic Accuracy Test
Page 3-30
Adjustments
Setups and procedures for adjusting your analyzer:
• Source Calibration Adjustment
• Receiver Calibration Adjustment
• LO Power Adjustment
• 10 MHz Frequency Reference Adjustment
• 3.8 GHz PMYO Frequency Adjustment
Page 3-38
a. The Agilent N7840A software package must be purchased separately.
Section Title Summary of Content Start Page
To Next Page
Loading...
Need help?
General
