2-6 Service Guide E8364-90026
General Product Information PNA Series Microwave Network Analyzers
Analyzer Options Available E8362B, E8363B, E8364B
Option 1CM, Rack Mount Flange Kit for Instruments without
Handles
Option 1CM provides a rack mount kit that contains a pair of flanges, rack mount rails,
and the necessary hardware to mount the analyzer in an equipment rack with 482.6 mm
(19 inches) horizontal spacing.
Additional kits may be ordered from Agilent. Refer to “Rack Mount Kits and Handle Kits”
on page 6-82 for the part numbers.
Option 1CP, Rack Mount Flange Kit for Instruments with Handles
Option 1CP provides a rack mount kit that contains a pair of flanges (cut to adapt to
handles), rack mount rails, and the necessary hardware to mount the analyzer in an
equipment rack with 482.6 mm (19 inches) horizontal spacing.
Additional kits may be ordered from Agilent. Refer to “Rack Mount Kits and Handle Kits”
on page 6-82 for the part numbers.
Option H08, Pulse Measurement Capability
This option enables additional firmware and hardware within the analyzer to allow you to
perform pulse measurements with you PNA. This option requires that Option H11 also be
installed.
Option H11, IF Access
This option adds additional hardware to your PNA that allows for external connection to
the internal IF path of the PNA. This option requires that Options 014, 080, 081, and UNL
also be installed.
Option UNL, Source Attenuators and Bias Tees
This option adds a 60-dB step attenuator and a bias tee between the switch splitter and
each of the ports. The step attenuators are used to adjust the power level to the device
under test (DUT) without changing the power in the reference path. The bias tees provide
a means of biasing active devices under test. DC bias for the bias tees is provided through
two rear-panel BNC connectors. These inputs are fused for protection.
To Next Page
Loading...
Need help?
General
