12 Agilent 1200 Series Valves
1 Installation and Configuration
Hardware Installation
Hardware Installation
The Agilent 1200 Series valves can be installed in two different ways. They can
either be placed on free bench space near the Agilent 1200 Series LC system or
they can be mounted on the G1383A Agilent 1200 Series column organizer.
The column organizer should be located on the right side of the Agilent 1200
Series stack, which includes the autosampler.
In order to install a valve on the G1383A Column Organizer the Organizer Rail
Assembly must be installed on the two mounting poles using the clips from the
Organizer Rail Assembly. All External Valves have a bracket on the side which
slides over the metal part of the Organizer Rail Assembly.
Two CAN connectors and one DC-CAN connector are located at the back panel
of the valve assemblies as displayed in Figure 1.
Figure 1 Back Panel of the Agilent 1200 Series Valves
CAN-DC-Out
CAN port
To Next Page
Loading...
Need help?
General
