Agilent Technologies G7081B User Manual

5 Operating in EI Mode
To Set the JetClean Parameters for the Clean Only Mode
130 5977B Series MSD Operating Manual
To Set the JetClean Parameters for the Clean
Only Mode
Procedure:
1 In Instrument Control view, click the MS Parameters icon.
2 In the Single Quadrupole MS Method Editor, select the JetClean tab. (See
Figure 42.)
3 From the Operation dropdown menu, select Clean Only.
4 Enter the parameters supplied by your method developer.
5 Save the method.
Figure 42 JetClean set to Clean Only mode

Agilent Technologies G7081B Specifications

General

Brand	Agilent Technologies
Model	G7081B
Category	Water Pump
Language	English