Agilent InfinityLab LC Series Vialsamplers User Manual 120
3Using the Module
Install the Optional Sample Cooler/Sample Thermostat
5 Slide the Sample Cooler/Sample Thermostat halfway
into the sampler.
Module is partially energized when switched off, as long
as the power cord is plugged in.
Repair work at the module can lead to personal injuries,
e.g. shock hazard, when the cover is opened and the mod
-
ule is connected to power.
Make sure that it is always possible to access the
power plug.
Do not use the Sample Cooler/Sample Thermostat if it
is not operating correctly or has been damaged. Dis
-
connect it from the power supply and call your local
service center.
Remove the power cable from the module before open-
ing the cover.
Do not connect the power cable to the module while
the covers are removed.
If the Sample Cooler/Sample Thermostat is discon-
nected from the power supply, you should wait for at
least five minutes before switching on the compressor.
Damaged electronics
To avoid damages of the electronics of the module
make sure the power cords are unplugged before dis
-
connecting or reconnecting the sampler to the Sample
Cooler/Sample Thermostat cables.
6 Connect the power cable and the data cable to the Sam-
ple Cooler/Sample Thermostat.
To Next Page
Loading...
Need help?
General
