Getting Started 1
N1913/1914A Installation Guide 21
USB
The USB interface requires no front panel configuration. USB operation
and configuration is supported by the version of VISA and SICL IO
libraries on your PC.
1 After I/O software is installed on your computer, connect your EPM
Series power meter to your PC using the supplied
Type A - Mini 5 pin USB cable.
2 The PC confirms the hardware connection.
3 The Found New Hardware Wizard automatically starts and guides you
through configuring the power meter as a USB device (see Figure 1- 1).
Click
Next to install the software automatically, accept all defaults to
complete the installation.
Figure 1-1 Found New Hardware Wizard
Before connecting the USB cable, ensure that the I/O software is installed in your
computer.
See “Remote Interface Configurations” on page 20 for information about Agilent IO
Libraries software. If you have installed other I/O software, refer to documentation that
accompanies the software.
To Next Page
Loading...
