3
GB
TECHNICAL DATA
1. Spindle
2. Anti-Seize Ring
3. Motor Unit
4. Tail Handle
5. Power Supply Cord
6. Control Panel
7. Water Feed Valve
8. Water Inlet Strainer
9. Information Screen
10. Rebar Assist Button
(also used to change from mm to inch display)
11. Motor On/O Button (Starts and Stops the motor)
12. LED Load Indicator
13. Diameter Selector Buttons
14. Bit Threading Button (only active when motor is OFF)
9.
6.
10.
11.
12.
13.
14.
7.
8.
1.
2.
3.4.
5.
Power Input 16 A, 3700 W (230 V)
Voltage 220-240 V, 50-60 Hz
Rated Load Speeds 220 - 540 /min
Drilling Capacity Ø 500 mm (20")
Gear Oil Type 80 W-90
Gear Oil Capacity 400 ml
Spindle Thread 1-¼" UNC male
Insulation Class Class 1 with RCD
Ingress Protection Class IP55
Weight 16.7 kg (36.7 lb)
* Due to the constant speed design, the no load speeds and rated load speeds are the same.
To Next Page
Loading...