GB
6
DRILL SAFETY WARNINGS
• Hold power tool by insulated gripping surfaces, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and could give the operator an electric shock.
• Check the ground (earth) connection of the electrical plug.
• If you detect a leak in any part of the water supply system, shut the machine down immediately
and repair the fault. Water pressure should not exceed 70 psi (4 bar).
• Take care not to damage gas, water, power and other conduits in the area of the drilling operation.
Drain or shut off these conduits as required.
• Block off the working area and place warning signs on both sides of the wall when drilling through
from one side to the other.
• Take appropriate precautions to ensure that, in the event of a drilling core dropping out, no
personal injury or material damage will result.
• When drilling hollow components, check the flow route of the cooling water in order to prevent
damage.
• WARNING: Pull the plug out of the socket before making device settings or changing accessories.
Many accidents are caused by accidental starting of power tools.
• When mounting the stand, fix the base to a firm, level, surface or wall. The power tool cannot be
guided evenly and safely if the base can slip or shake.
• This diamond core drill cannot be used for overhead drilling unless special water control
equipment is used.
WARNING: Hazardous situation due to broken parts: Always check core bits before using. Deformed or
damaged drill core bits must not be used;
WARNING: Use of non-recommended cutting tools can lead to injuries due to the loss of control. Only
use drill core bits designed for this machine only. Follow the minimum and maximum diameter given on
Symbols used in this manual
V…….........volts
A…….........amperes
Hz…….......hertz
W……........watt
~………....alternating current
n
………...rated speed
min
-1
….......revolutions or reciprocation
per minute
.........warning of general danger
.........with electrical earth
.......read these instructions
......always wear eye protection
......always wear a dust mask.
.....always wear hearing protection
.....wear safety-approved hard hat
do not dispose of electric tools,
accessories and packaging together
with household waste material
To Next Page
Loading...