Installation-, Operating-, Maintenance-Manual, Spare part List MAK10
AGT-PSG GmbH & Co.KG
Errors and printing mistakes excepted
Page 17
Translation - Manual MAK10 Rev. 11/2017
Commissioning
General Instructions / Pre-Conditions
Pre-conditions: The sample gas conditioner is correctly mounted. The feed lines are connected. The
electrical connection is built up. Notice chapter „Assembly and Installation“!
If damages are discovered after initial operation, the user is committed to undertake any action to avoid
consequential damage. First actions could be to switch off the sample gas flow and the main power
connection.
Qualified personnel must perform the start-up. When installing and operating this equipment,
comply with all national electrical code and any applicable federal, state and local codes. Who is
operating the unit is responsible for the proper and safe operation of the cooler.
CAUTION! Exceeding of operating parameters! Verify that the operating parameters match
with the nominal values stated on the data nameplate of the cooler (voltage, frequency, gas
flow rate, gas inlet temperature, ambient temperature, etc.).
WARNING! Open housing! Never operate equipment with panels removed.
To Next Page
Loading...
Need help?
General
