Need help?Do you have a question about the AGV AX9 and is the answer not in the manual?
General| Visor | Anti-scratch |
|---|---|
| Ventilation | Adjustable front and rear vents |
| Safety Standard | ECE 22.05 |
| Retention System | Double D-ring |
| Shell Size | 3 |
Procedure for detaching the visor from the helmet shell using a screwdriver or coin.
Process for attaching the visor to the helmet, ensuring correct movement and torque.
Instructions for cleaning the visor with soft cloth, warm water, and neutral detergent.
Steps to fit the Pinlock insert onto the visor, securing it with special ratchets.
Method to detach the Pinlock insert from the visor by gently bending the insert.
Guidance on cleaning the Pinlock insert using liquid detergent and a soft cloth.
Procedure for removing and installing cheek pads and neck roll using press studs and hooks.
Steps to remove and install the crown pad using front and rear press studs.
How to install and remove the wind protection by inserting plastic teeth into the chin guard.
Procedure to remove and reinstall the chin strap cover using a press stud.
Instructions for hand washing inner components in warm water with laundry detergent.
How to open, close, remove, and install the external chin guard air intake slider.
How to open, close, remove, and install the internal chin guard air intake slider.
How to open and close the front air intakes using a sliding mechanism.
How to adjust the peak position by replacing mechanisms or tilting the peak.
Procedure for removing the peak by loosening screws and removing cover plates.
How to install the peak by securing it with screws and fitting cover plates.
How to fasten the chin guard strap through rings and secure it with a press stud.
How to open the retention system by releasing the press stud and loosening the strap.
To Next Page
