AIBAO YB702A - Securing Your Baby; Securing Your Baby Using the Baby Insert; How to Adjust the Belts, Headrest and Seat Posi Ons

Securing your baby
3.1 Securing your baby using the baby insert
3. Securing your baby
CAUTION
The baby insert is used to provide extra comfort
for very small babies, and it gives your baby the
necessary support while he or she is sll small.
Please use the baby insert aached to this car
seat when your baby 's weight is less than 15kg.
For the protecon of your baby
Always secure your baby in the car seat using the harness.
Never leave your baby unaended in the car seat when placing it on elevated
surfaces (e.g. a table, nappy changing unit, etc.).
Never allow the strap end to become caught in moving parts (e.g. automac
doors, escalators, etc.).
Cauon! The plasc parts of the car seat heat up in the sun, so that your baby
may get burnt. Protect your baby and the car seat against intensive solar
radiaon (e.g. by pung a light cloth over the seat).
Take your baby out of the car seat as oen as possible to relieve its spine. We
recommend frequent breaks during long journeys. Even outside of the car,
please avoid leaving your baby in the car seat for too long.
Baby Insert
Securing your baby
3.2 How to adjust the belts, headrest and seat posions
3.2-1 Adjusng the belts
3.2-2 Eight heights of the headrest
IMPORTANT
The correct belt height of the shoulder belts is
aained when the belt disappears into the shell slightly above the
shoulder of the child.
Make sure that the shoulder belts fit properly over the shoulders of
the child.
Loosen the harness straps by pressing the release
buon and pulling the harness straps as far as you
can.
Note! Do not pull the shoulder pads.
The headrest can be set at five different heights in
group I mode. There are three addional
posions in Group II & III mode once the shoulder
pads and harness straps has been removed.
Press and pull the handle behind headrest.
It is important to make sure the headrest fit properly
to head.
07 08