Securing your baby
CAUTION
Do not twist or interchange the harness straps.
Slide buckle tongues together
and insert them in the buckle
with an audible sound “ click”.
Pull the straps ght by the
harness adjustment strap, and
make sure the ghtness is
comfortable to your kid.
The correct belt height of the shoulder pads is aained
when the strap disappears into the shell slightly above
the shoulder of the child.
Make sure that the harness straps fit properly over the
shoulders of the child.
Click
Loosen the harness straps and
open the harness buckle, then
place the harness straps to the
sides of the car seat.
Put the baby into the car seat.
3.4 Tightening the harness
CAUTION
Pull the straps end straight towards you, not upwards or downwards.
aaaaaaaaaaaaa
Please pay aenon to the strap end. Whilst traveling (especially outside
the car) it should always be aached to the cover.
09 10
Installaon in the vehicle
4.1 Installaon of Group I and it is for the children whose
weight between 9-18kg.
Group I : Forward facing installaon(suitable for the child weighing
from 9kg to 18kg)
Place seat on the vehicle seat without any incline,
ensuring its backrest be placed firmly against the
vehicle seat.
NOTE:
Before place the restraint, please ensure
the vehicle seat back is end long.
The harness strap could not be twisted.
The restraint backrest must be placed
ght against the vehicle seat, without gap.
Enter into the buckle tongue unl you hear
a clear “click”. Then ghten the vehicle belt
by pulling back the slack parts. Make sure
the seat is stable and secure.
Please do not leave your child unaended in the child safety
seat in the vehicle.
Pull the 3 point belt (lap and
shoulder belt) through the belt
guides at the backrest & boom
part of the car seat.
3.3 Securing your baby using the harness
To Next Page
Loading...