2.7.3 The blood pressure and pulse rate are displayed when the
measurement completed.
The cuff is deflated automatically, and all of the measurement
results are stored in the memory.
The “ ” symbol will be displayed if irregular heartbeat is detected.
13
2.7.2 Measurement start. When pressurized to stop blood flow, the
Blood Pressure Monitor stops pressure before automatically leaking
air and measuring blood pressure.
The heartbeat symbol flashes when a pulse is detected.
When the heart beat symbol appears and flashes, the Blood
Pressure Monitor detects the pulse and begins to calculate the
pulse automatically.
2.7.4 Press the “ ” button to turn off the unit.
The unit will be automatically turned off after two minutes if no
more operation.
NOTE: The inflation or measurement can be stopped by pressing
the “ ” button at any time.
2.8 Use the Memory function
The unit stores the blood pressure and pulse rate in the memory
after completing a measurement each time. 2x120 sets of
measurement values can be stored automatically.
The earliest record will be deleted automatically to save the latest
measurement value when more than 2x120 sets.
The unit also calculates an average reading based on the values
of the latest 3 times measurement .
To Next Page
Loading...