- 13 -
How to Install
■ IXG-MK
● Mounting the station on a wall
Back wiring
Surface wiring
• If the accessory screws are unusable for plaster board or a concrete wall, etc., please use a product such as an anchor
or concrete plug (not included).
2
3
1
4
4
Attach the station to the
mounting bracket.
Attach the
handset.
Cat-5e/6 cable
3-gang box
Low-voltage
lines
Low-voltage lines
Mounting bracket
(attached to the
back of the station)
Mounting-bracket screws
(included) × 4
Option connector (included)
Station
※Insert a microSD card into the microSD card
slot if needed.
Connect the option connector (included) and the low-voltage
lines using crimping method, then connect the option connector,
the low-voltage lines and Cat-5e/6 cable.
Attach the mounting
bracket.
① Insert the
connector into
the station until
it clicks.
② Set the
handset on the
station.
Recommended Mounting
height (center of gang
box) 1,500mm (4' 11'')
※
Wire mold
(Please prepare separately)
Please decide the size of the wire mold
according to the wiring cables to accommodate.
92mm (3-5/8'')
83.5mm
(3-5/16'')
Mounting bracket
(attached to the back
of the station)
Wall-mounting wood screws
(included) x 4
Station
Connect the option
connector
(included), the low-
voltage lines, and
Cat-5e/6 cable to
the station, and
position them as
shown.
Wire mold
80mm (3-1/8'')
or less
Use a covering duct for Cat-
5e/6 cable and low-voltage
lines, and leave a space
(exposed portion) of no
more than 80mm (3-1/8'')
between the station and the
covering duct.
Recommended
Mounting height
(center of mounting
bracket) 1,500mm (4'
11'')
To Next Page
Loading...
