- 15 -
■ IXG-DM7, IXG-DM7-HID
Back Box for Entrance Station (IXG-DM7-BOX) is sold separately.
The illustrations explain installation using the IXG-DM7 model.
• When installing the station on a rough surface, please seal the station edges to prevent water entering the station. If the
station edges are left unsealed on a rough surface, IP65 ingress protection rating is not guaranteed.
• If the embedded box is exposed, water and dust will enter through the opening of the embedded box, and IP65 is not
fulfilled.
23
4
1
8
6
5
7
Make a hole for the cable.
Install the back box in the
wall.
Attach the mounting bracket
to the back box.
Connect the option
connector (included) and the
low-voltage lines using
crimping method.
Slide the terminal cover left,
and open up it.
Insert the option connectors and Cat-5e/6
cable to the station. Insert a micro SD card into
the micro SD card slot if recording function is
used.
• Push the micro SD card in until you hear it click into
place.
• The micro SD card indicator will light red while mounting
the micro SD card.
• To take the microSD card out, push the [microSD card
eject] button (SW2) on the back of the station one time
(The microSD card indicator will turn off. Do not remove
the card while the indicator is lighting). When the
indicator turns off, push the microSD card until you hear
a click, then remove.
Replace the terminal cover.
Be sure to close the terminal cover when
done. If left open, condensation or water
may enter, preventing heat dissipation and
causing damage.
Fasten the station to the
mounting bracket with the
special screws.
Special
screw
(cannot be
removed)
Mounting-bracket
screws x4 (included)
156mm
(6-1/8”)
317mm
(12-1/2”)
Recommended
Mounting height
(box center)
1,380.5mm (4' 6")
60mm
(2-3/8”)
Low-voltage
lines
Cat-5e/6
cable
Option connectors
(included)
Tighten
Loosen
Special screwdriver
(included)
Loosen
Special screwdriver
(included)
Tighten
Back box
Special screw (cannot
be removed)
micro SD card indicator
To Next Page
Loading...
