22
How to use
Answering a call
3
Answering a call
If there is an incoming call from Guard Unit, Tenant Unit, or Common Inside Area, the system will automatically enter
communication.
1. Speak with the other party.
• The audio guidance may be played.
2. Tap to end
communication.
Note
• If an incoming call or page with a higher priority is received
from another station during communication,
communication will be interrupted and the station will
switch to the call or page with higher priority.
• If the call duration that was previously set on the
destination station elapses, communication will
automatically end. A notification tone will play
approximately 10 seconds prior to communication ending.
• The communication will automatically end after
approximately 10 seconds if the door is released on the
destination station, depending on the settings.
• Depending on the configuration, the unlock tone or audio
guidance may play when the door release is unlocked on
the destination station.
• The call duration cannot be extended on this station. If the
communication is extended on the destination station, the
call duration will be extended approximately 10 minutes.
• Video and audio may be automatically recorded during
communication, depending on the settings.
To Next Page
Loading...
