Aiphone IXGW-GW - Page 7

7
Association Settings
From the top menu, select Connection and click Association Settings. Here, stations created in the previous steps will be
associated to stations found on the network. Select a station from the Station Settings List and one from the Station List
below. Clicking
Apply
will assign the Station Name and IP Address to the station, and that station will quickly reboot.
Scroll down to conrm the stations were successfully associated. If the wrong station information was associated to a station,
select that station on this list and click
Remove Association
. Once removed, scroll up and associate the station correctly.
If a Station Search fails immediately, go to File from the top menu and select IXG Support Tool Settings. Find the Select
NIC drop-down and select the correct NIC Support Tool should use, and click
OK
. Return to Association Settings
to try again. If the Station Search continues to fail immediately, a local antivirus or rewall may be preventing this
action. Disabling one or both of these may be a simple solution in quickly nishing the initial system conguration.
Associated Station List
Typically, stations deployed across a
managed network cannot be found
by Support Tool unless the network
is congured to allow this broadcast
search. In this case, it may be easier
to move the stations to a switch
local to the programming PC than it
would be to congure the network
to allow a network-wide broadcast.