11
PART NAMES USING THE SYSTEM APPENDIX
SETTING AND ADJUSTMENT
SETTING AND ADJUSTMENT DETAILS
Call settings [CALL]
You can make the following settings for call.
■
Designate door stations allowed to call-in to
this station [DOOR STATION SETTINGS]
You can set whether or not this station receives a call from
the door station 1 to 4. Individual settings can be programmed
for each door station. When there is a call from a door station
that is set to “DISABLE”, no call tone sounds and no image is
displayed on this station.
From HOME window, touch
1
SETTINGS
→
CALL
→
DOOR STATION SETTINGS
.
The PIN entry window is displayed.
Enter the 4-digit PIN by using the touchscreen, and
2
then touch
ENTER
.
“DOOR1” to “DOOR4” are displayed.
If a wrong PIN has been entered, an error message
*
is displayed. Enter correct PIN. (See page 10 for PIN
settings).
To change the setting for “DOOR1”, select “ENABLE”
3
or “DISABLE”.
ENABLE ......Allows this station to receive a call from door
station 1.
DISABLE .....Does not allow this station to receive a call
from door station 1.
Repeat for other door stations.
4
When the setting has fi nished, touch
5
ENTER
.
■
Designate sub master station(s) to receive a
call from this station [ROOM STATION CALL
SETTINGS]
You can set whether or not the sub master stations receive a
call (all call or single call) from this station. The setting can be
made for each sub master station. A sub master station set to
“DISABLE” will not receive a call from this station.
From HOME window, touch
1
SETTINGS
→
CALL
→
ROOM STATION CALL SETTINGS
.
The PIN entry window is displayed.
Enter the 4-digit PIN by using the touchscreen, and
2
then touch
ENTER
.
“ID2” to “ID8” are displayed.
"ID2" shows the sub master station whose ID switch is
*
set to “2”. (The same applies to "ID3" to "ID8".)
If a wrong PIN has been entered, an error message
*
is displayed. Enter correct PIN. (See page 10 for PIN
settings).
To change the setting for “ID2”, select “ENABLE” or
3
“DISABLE”.
ENABLE .....Allows the sub master station to receive a
call from this station.
DISABLE ....Does not allow the sub master station to
receive a call from this station.
Repeat for other sub master stations.
4
Use "
*
" or " " to scroll between sub master stations.
When the setting has fi nished, touch
5
ENTER
.
To Next Page
Loading...
