15
PART NAMES USING THE SYSTEM APPENDIX
SETTING AND ADJUSTMENT
Settings for external alarm/external device
[GENERAL] - [ALARM SETTING] -
[UTILITY SETTING]
This setting is available when the inputs 1, 2, and/or 3 of
*
this station is set to “UTILITY” by the [INSTALL] menu, and
an external device, such as a sensor or a call button is
connected to each of the inputs.
Make the following settings.
■
Enabling/Disabling ALARM AT DOOR
Enable or disable Door station 1 to sound alarm and turn on
the white LED at door when connected external devices on this
station are triggered.
■
Setting the duration time of sounding alarm
[ALARM DURATION]
You can set the duration time of alarm that sounds at the
master and sub master stations. This is also applied to the
alarm at door station 1 when "ALARM AT DOOR" is set to
"ENABLE".
Setting range:
10 seconds, 1 minute, 10 minutes, 1 hour, CONTINUOUS (no
time restriction)
"CONTINUOUS" is available only when "ALARM AT
*
DOOR" is set to "ENABLE".
From HOME window, touch
1
SETTINGS
→
GENERAL
→
ALARM SETTING
→
UTILITY SETTING
.
Touch
2
ALARM AT DOOR
and select “ENABLE” or
“DISABLE”.
Touch
3
ALARM DURATION
until the preferred time is
displayed.
When the setting has fi nished, touch
4
ENTER
.
Formatting an SD (or SDHC) card
[GENERAL] - [SD CARD]
SD (or SDHC) cards require formatting when using them in this
station for the fi rst time.
When formatting
*
an SD (or SDHC) card, all existing data on
card is erased.
To
*
[EXPORT RECORDED IMAGES], refer to page 28.
From HOME window, touch
1
SETTINGS
→
GENERAL
→
SD CARD
→
FORMAT SD CARD
.
A notice message is displayed.
Touch
2
YES
to continue with formatting.
To cancel formatting, touch
NO
.
When "SD CARD FORMAT COMPLETE" is displayed,
formatting is complete.
It may take long until formatting has been complete.
*
To Next Page
Loading...
