Operating the Machine
Stopping the Machine
Release the OPC Bail Arm to stop the machine. If the engine fails to stop,
pull the spark plug lead loose from the engine.
Cutting Height Adjustment
Your machine is shipped with the cutting disc in the highest position. Follow
these steps to adjust to the desired height of cut:
(1) Turn the petcock to the “off” position.
(2) Disconnect the spark plug.
(3) Tilt the machine onto its left side, keeping the carburetor up.
(4) Wearing protective hand gear, remove the Disc Securing Bolt
with holding the cutting system.
(5) Remove the three spacers and the cutting system.
(6) Reposition the spacers and cutting system for desired height of
cut.
(7) Fit the Disc Securing Bolt back to the machine.
Note: Large spacer must be positioned directly below the impeller at all
times.
Prevent An Accident
Inspect the cutting area before using the mower. Any objects other than grass
and leaves should be removed to prevent them from becoming projectiles.
Inspect for hidden obstructions, which would cause health and safety risks
when coming in contact with the cutting system. Make note of the
obstructions and mow around them.
Page| 15
To Next Page
Loading...