Machine Maintenance
Keeping the Engine Clean
Remove all debris and grass from the engine, including the exhaust and
exhaust guard, air ways in the top cowl, and surrounding deck areas on a
daily basis or after each use. Do not pressure-wash the machine during
cleaning. Water can contaminate the fuel. Always clean with a brush or
compressed air.
Grass and debris may clog the engine’s air cooling system especially after
prolonged operation or cutting tall, dry grass. The internal cooling fans and
surfaces may require cleaning to prevent the engine from overheating. We
recommend that this be carried out by a Honda Authorized Dealer.
Deck Housing
Remove debris and grass from both sides of the deck immediately after each
use.
Nuts and Bolts
Check all securing nuts and bolts regularly to ensure they remain tight.
Replace missing or damaged items immediately.
Oil Maintenance
Before each use, check the oil level and ensure that a correct oil level is
maintained. Refer to the “Before Starting the Machine” section for
instructions.
Change the oil after the initial first five hours of use. Follow the maintenance
schedule thereafter.
(1) Run the engine until the fuel tank is empty.
(2) Remove the spark plug lead.
(3) Allow the engine to cool.
(4) Drain the oil while the engine is warm (not hot).
(5) Tip the machine over on to its left side (keeping the carburetor side up).
(6) Drain the oil into a suitable container.
(7) Refill with a high-grade 10W-30 synthetic oil.
Page| 17
To Next Page
Loading...