Maintenance Schedule
Page| 20
Service Schedule Maintenance
Before Each Use
(1) Check the fuel and oil levels
(2) Check blade system and tighten any loose bolts
(3) Check air filter – ensure it is dry
(4) Remove debris from the cutting system, impeller,
and air intake area of engine
After the First 5 Hours
(1) Change the engine oil (first machine oil change)
Every 5 Hours
(1) Tighten/replace any loose/damaged bolts, blades or
cutting disc
Every 25 Hours
(1) Check and clean the air filter area.
Every 50 Hours
(1) Change the engine oil
(2) Clean/replace air filter
(3) Sharpen/replace blades
(4) Clean/replace fuel filter
(5) Check for any leaks or deteriorations in the fuel
system and hoses
Every 100 Hours
(1) Inspect the spark plug
(2) Clean/replace air cleaner
(3) Clean the cooling system (fins/starter area)
Every 150 Hours
(1)Replace air filter
(2) Replace spark plug
Storage Over 30 Days
and Winterized Storage
(1) Empty fuel and oil
(2) Turn off fuel valve
(3) Disconnect the spark plug
(4) Add 15ml of fresh oil to the cylinder and pull starter
once to distribute oil
(5) Treat metal parts with water-repellant, anti-
corrosion product.
(6) Store in dry, ventilated area
This is a suggested maintenance schedule. Depending on terrain, the schedule
may need to be adjusted for dusty/rough conditions.
To Next Page
Loading...