Air Liquide OP 310 - Operation and Maintenance: Troubleshooting; Repair Procedures and Equipment Disposal

15
9.3 Repairs
For safety reasons, repairs may only be carried out in author-
ized workshops or by the manufacturer.
Only original spare parts shall be used.
After each repair, the manifold must be checked for function
and tightness. When putting the station back into operation
thefirstthingtodoistopurgethestationwithinertgas(e. g.
nitrogen).
In the event of improper repairs by unauthorized workshops,
modifications to the station or the use of non-original parts
immediately voids all liability and warranty of the manufac-
turer.
For further information please contact our personal at your
disposal.
9.4 Disposal and recycling
At the end of the equipment’s useful life or when it is impos-
sible to repair it, it is essential to respect the local regulations
forrecycling / disposalofourequipment.Topreventreuse,
these products must be unsuitable for use.
In accordance with EU Directive 2018/851 on waste, the
owner of the equipment ensures that when recovery is not
carriedoutinaccordancewitharticle10,thewastewillbe
subjected to safe disposal operations that comply with the
provisionsofarticle13ontheprotectionofhumanhealth
and the environment.
The licensee must take steps to promote high quality recy-
cling and, to this end, must establish separate waste collec-
tions when technically, environmentally and economically
feasible and adequate to meet the quality standards required
by the relevant recycling sectors.