Why does my Aircare Humidifier not operate on any speed setting?
If your Aircare Humidifier isn't operating on any speed setting, first, ensure the polarized plug is fully inserted into the wall outlet. Also, the fan won't work if the unit has run out of water, so refill the reservoir. Finally, check the float assembly and ensure it is correctly positioned.
What to do if the motor does not turn on in my Aircare SS390DWHT Humidifier?
If your Aircare Humidifier's motor doesn't turn on, it could be due to overheating, which may have tripped the motor's temp-sensing fuse. If this has occurred, take the unit to an authorized service station for repair and do not attempt electrical repairs yourself. Another possibility is that the wick may be installed incorrectly; remove and reinstall it correctly.
What to do if my Aircare Humidifier doesn't turn on at any speed?
First, make sure the polarized plug is fully inserted into the wall outlet. If that's not the issue, the unit may have run out of water and turned off automatically; refill the reservoir. Lastly, check the float assembly to ensure it's correctly positioned as described in the “Water Fill” section, as improper positioning can prevent operation.
What to do if the motor in my Aircare SS390DWHT doesn't turn on?
Check the motor/fan operation, but exercise caution and avoid touching the fan during this test, as the motor may suddenly turn on. Also, the wick may be incorrectly installed, so remove and reinstall it correctly.
What does flashing “20” mean on my Aircare SS390DWHT display?
A flashing “20” indicates that the room humidity is lower than 20%. The display will show the actual humidity once the level reaches 25%.
What does “00” mean on my Aircare SS390DWHT display?
If the display shows “00”, the unit has just been turned on and is initiating. It also could mean that the fan speed is in standby.
What does flashing ”—“ mean on my Aircare SS390DWHT Humidifier display?
A flashing "--" indicates that the room humidity is over 90%. The display will remain until the humidity drops below 90%.
Why is my Aircare Humidifier not producing enough humidity?
If your Aircare Humidifier isn't producing enough humidity, it might be due to an old or clogged wick. Replace the wick if it's hardened with minerals. Alternatively, the humidistat setting may be too low; try increasing the humidity setting on the control panel.
What to do if my Aircare SS390DWHT produces too much humidity?
If your Aircare Humidifier is creating too much humidity, leading to condensation, the humidistat may be set too high. Try reducing the humidistat setting or increasing the room temperature.
Why is my Aircare Humidifier leaking water?
If your Aircare Humidifier is leaking water, it might be because the cabinet was overfilled. Do not overfill the cabinet; the correct water level is indicated inside the cabinet side wall.
Provides essential safety guidelines for operating the humidifier.
Explains the mechanism of how the humidifier adds moisture to the air.
Instructions for attaching the caster wheels to the humidifier base.
Detailed steps for installing the evaporative wick assembly.
Chart detailing ideal indoor relative humidity based on outdoor temperature.
Overview and explanation of the humidifier's control buttons and display.
Explanation of indicator lights, messages like 'F', 'CF', and their meanings.
Steps to remove mineral buildup using vinegar solution.
Procedure for disinfecting the humidifier using bleach solution.
Guidelines for properly storing the humidifier during the off-season.
General| Type | Evaporative |
|---|---|
| Tank Capacity | 3.5 gallons |
| Run Time | Up to 70 hours |
| Color | White |
| Fan Speeds | 3 |
| Humidistat | Yes |
| Filter Type | Wick filter |
To Next Page