AIROS 8 - Secondary Operating Modes & Instructions; Secondary Operating Modes; Operating Instructions - Preparation

9
A8IFU.0001 REV C
Device Operation Specications (cont.)
Secondary Operating Modes
The AIROS 8 can also be used in two secondary Operating Modes: Focal Mode or
Clearing Mode.
• Focal Mode: User can choose to utilize this mode to tenderize the tissue in
a limb or limbs affected by Lymphedema Fibrosis. Treatment can be applied
using four specic chambers in the garment (1-4, 2-5, 3-6, 4-7 or 5-8, selected
by the user). Focal Mode can be used prior to Gradient Mode therapy or
Pressure Mode therapy.
• Clearing Mode: User can utilize this mode to mimic manual lymphatic
drainage. Clearing Mode can be used prior to Gradient Mode therapy or
Pressure Mode therapy.
Operating Instructions
1. Unpacking the Equipment
1.1. Open the shipping box and remove the device.
1.2. Remove the protective foams and bag.
1.3. Remove the garments from the bag.
1.4. Unroll the tubes and unroll the garment by spreading it out at.
2. Preparing for Operation
2.1. Place the device on a at, sturdy surface in close proximity to where the
user will utilize therapy.
2.2. Secure the proper end of the POWER CORD to the POWER PLUG on the
Back Panel of the device. Secure the other end of the POWER CORD to a
safe outlet. Outlet should be 120 VAC, 60 Hz.
2.3. Attach GARMENT CONNECTORS of the garment to the GARMENT
CONNECTOR PORTS on the Front Panel of the device.
NOTE: For unilateral therapy (applying treatment to only one arm or
one leg), place the AIR BLOCKER in the other GARMENT CONNECTOR
PORT that is unused.