Usage Precautions
DEHUMIDIFIER
DEHUMIDIFIER
1. Do not use a rusty power cord:
- Do not use a rusty power cord, extension cord, or plug.
- Otherwise, it may cause a fire, electric shock, or overheating.
2. Do not place this machine near stoves, heaters, or other heating devices:
- Otherwise, plastic parts may melt, potentially causing a fire.
3. Do not use the dehumidifier in places where it may be exposed to direct sunlight,
wind, or rain:
- This machine is for indoor use only.
4. If any problems occur (such as a burning smell), immediately turn off the machine
and unplug the power cord:
- Otherwise, it may cause a fire, electric shock, or new malfunctions.
5. Tips for extending the life of the air purification filter:
- When not in use for a long time, seal the air purification filter in a plastic bag.
6. Do not use the dehumidifier in places where it may get wet:
- If the machine gets wet, it may cause an electric shock, resulting in fire or other
electrical accidents.
7. Use an appropriate power switch:
- Otherwise, it may cause a fire or electrical accident.
8. Do not damage or alter the power cord:
- Do not place heavy objects on, heat, or alter the power cord, as this can damage it
and cause a fire or electric shock.
9. Ensure the power cord is securely connected to the power switch:
- A loose power cord may pose an electric shock hazard.
10. Do not stop the dehumidifier by pulling out the power cord:
- Doing so may cause a fire or electric shock.
4. Timer Switch Instructions:
● While in the on state, you can set a timer for automatic shutdown. While in the off
state, you can set a timer for automatic startup. Setting both timer on and timer off
will activate the cyclic timer mode.
A. Timer On Setting: While in the off state, press the "Mode" button. The "timer On"
icon will flash, and the time display area will also flash to indicate the timer setting.
Press the "+" or "-" button to adjust the timer setting. Each press will produce a beep,
and if you press and hold for 2 seconds while adjusting by 1, the adjustment will
continue automatically. After adjusting to the desired time, if there's no operation for
10 seconds, the machine will accept the setting, and the "timer On" icon will continue
to flash. (Setting range: 0 to 24 hours, default is 0 hours)
B. Timer Off Setting: While in the on state, press the "Mode" button. The "timer Off"
icon will flash, and the time display area will also flash to indicate the timer setting.
Press the "+" or "-" button to adjust the timer setting. Each press will produce a beep,
and if you press and hold for 2 seconds while adjusting by 1, the adjustment will
continue automatically. After adjusting to the desired time, if there's no operation for
10 seconds, the machine will accept the setting, and the "timer Off" icon will contin-
ue to flash. (Setting range: 0 to 24 hours, default is 0 hours)
Defrosting Method Explanation:
Automatic Defrost:
Defrost on a timer
Sensors are normal
1、"Entering condition (simulta-
neously satisfied):
2、1. The compressor runs
continuously for 30 minutes,
and the detected coil tempera-
ture is ≤ 30℉, triggering the
defrost mode.""2. During
defrosting, the compressor
stops running, while the fan
continues to operate, and the
defrost indicator light is on."
3、Defrosting Method
When in defrost mode, defrost for 8 minutes, then exit
the defrost mode once the time is up.
04 05
To Next Page
Loading...