Special Reminder
DEHUMIDIFIER
Specification Overview
DEHUMIDIFIER
1.Special Reminder to Users:
1. The humidity sensor is a precision component. Its use in environments with strong
corrosive gases and high dust levels may cause the sensor to malfunction.
2. This machine does not have explosion-proof capabilities. It is strictly prohibited to
use it in environments with flammable or explosive gases, dust, chemicals, biological
products, or other special requirements.
3. If the machine is damaged due to use in the above environments, it is not covered
by the warranty.
4. When installing this machine, grounding protection measures must be taken to
ensure safety during use.
5. Water discharge will occur after the machine has been running for a period of time.
Please pay attention to proper drainage.
6. To reduce malfunctions and extend the lifespan, avoid using excessive force when
operating the buttons.
7. The humidity sensor may have slight deviations from actual humidity due to its
position, environment, and temperature. This is a normal phenomenon.
8. During operation, cooled air will be discharged after passing through the condens-
er, resulting in higher outlet temperatures compared to ambient temperatures. The
emission of hot air is a normal phenomenon.
9. Dehumidification capacity is dependent on environmental temperature and
humidity. Higher temperatures and humidity levels result in greater dehumidifica-
tion capacity, while lower temperatures or low humidity conditions will lead to
reduced dehumidification capacity. This is a normal phenomenon.
Specification Table:
MODEL
Power Supply
Rated Power (86°F 80% RH)
Rated Current (86°F 80% RH)
Low Side Pressure
High Side Pressure
Refrigerant:
Motor FLA:
Motor Compressor:
Product Dimensions:
Gross Weight:
Applicable temperature:
AP138-2302
AC 115V/60Hz
1410 W
12.5 A
290psig
650psig
R32/(16.22oz)(460g)
2.13A
RLA:11.8A ;LRA:54A
21.65*19.57*37.6 in
86lb
41-95℉
08 09
To Previous Page
Loading...