Set-up Your Skye
Plug power cord into Skye
and wrap any excess cord
around the base.
Li Skye back up and place it
an open space to aid airflow.
Plug the power cord into a power
outlet and tap the power buon
(on back).
Lay Skye down on its side
(avoid laying on its face).
Unscrew the base cover
(turn counterclockwise).
Remove the PRO-Cell filter
from Skye.
Remove outer plasc bag
from PRO-Cell filter.
Remove the UVC lamp
from the box.
Hold the base of the lamp
and plug into Skye unl you
hear a click.
Place the "PRO-Cell" filter back into
Skye. Close the base cover by aligning
the arrows and then turning clockwise
into the locked posion. If the cover
is not completely flush with the base,
the unit will not operate.
FLIP OVER FOR
HOW TO USE SKYE
Download the “air health IAQ”
app to complete set-up and
enable controls from your phone.
To Next Page
Need help?
General
