5
Interior
Flying Cloud 5-9
Lavatory Faucet
Moen, Chateau Single-handled Filtered Kitchen Faucet
w/Protégé Side Spray - Model F7430
Operation instructions for the faucet, battery, and
lter replacement instructions are in the Moen faucet
manual provided in your owner’s packet. The lter and
battery for the faucet are located under the sink in the
galley cabinet. The battery and faucet replacement kit
number is #9601. It is available from Moen, phone:
1-800-BUY MOEN.
Faucet Cleaning and Care
All that is needed to clean your faucet is a soft, damp
cloth. Moen does not recommend the use of scour
pads, cleansers, or chemicals. The abrasive nature of
these substances could damage the faucet’s nish. A
non-abrasive car wax will help to protect the nish.
note
Do not submerge or place faucet head in
dishwasher.
If you have questions concerning either faucet, please
call the Moen toll-free help lines:
1-877-DRINK-H20
Monday through Friday - 8:00 a.m. to 8:00 P.M.
1-877-374-6542
Saturday - 8:00 a.m. to 6:30 p.m.
Electrical
Battery/12-Volt System Information
The major portion of electrical power in your
Airstream is 12-volt. The 12-volt current powers all
gas appliances for controls and/or ignition as well as
lighting. An exception would be the range which has its
own ignition source.
All 12-volt current comes through the battery
system in the front of your trailer. The batteries
are accessible in the battery box on the A-frame of
your trailer. Power from the batteries goes to a set
of four Type 2 thermal breakers located under the
front bed and riveted to the inside skin front plate.
The breakers are tied together by a brass bus bar.
One breaker (30 amp) protects the 12-volt tow
vehicle charge line coming from the 7-way cord.
Another breaker (20 amp) feeds the trailer brakes
breakaway switch located near the hitch coupler.
A 50-amp breaker feeds the battery disconnect
relay. The current leaves the relay and travels to the
12-volt distribution panel, located in the converter,
and then to the rest of the trailer. Open the brown
decorative door on the front of the converter under
the dinette to access the panel and its fuses. A
12-volt layout diagram is shown in Section 8 -
Maintenance.
If you replace a blown fuse and it immediately blows
again, do not replace the fuse again until a qualied
service technician can correct the problem.
If the replacement fuse holds for a week or more
and the gap in the fusible metal is barely melted
apart, this usually indicates an overload condition.
Reducing the number of lights or appliances used
on that particular circuit at the same time could
prevent any further fuse failure.
Refer to Section 8 - Maintenance for important
battery maintenance information.
Battery Disconnect Switch
The disconnect switch is used to separate the
batteries from the 12-volt distribution panel and
converter charging system.
When the switch is turned to USE (on) and the
trailer is plugged into a 110-volt shoreline, the 12-
volt distribution panel will receive power from the
converter and the batteries will be charged through
the converter charging system.
To Next Page
Loading...
